7
PRE SET-UP INSTRUCTIONS
When choosing a location for the unit please follow
guidelines below:
DO NOT:
• DO NOT
install near flammable gases.
• DO NOT
install near any source of heat, steam, or
combustible gas.
• DO NOT
install anywhere where poisonous or sultry gases
are generated.
• DO NOT
install in areas exposed to sea breezes.
• DO NOT
install near the doorway.
• DO NOT
install the indoor unit in a location subject to direct
sunlight.
• DO NOT
install indoor unit near TVs or radios.
• DO NOT
kink the refrigerant line set.
• DO NOT
clean the air conditioner with excessive amounts
of water.
• DO NOT
clean the air conditioner with combustible cleaning
agents. Combustible cleaning agents can cause fire or
deformation.
• DO NOT
operate the air conditioner with wet hands. This
may cause electric shock.
• DO NOT
use device for any other purpose than its intended use.
• DO NOT
climb onto or place objects on top of the outdoor unit.
• DO NOT
allow the air conditioner to operate for long periods of
time with doors or windows open, or if the humidity is very high.
• DO NOT
put the end of drain hose in water or a container that
will collect water.
CAUTION:
• When drilling the wall hole for line set, make sure to avoid
wires, plumbing, and other sensitive components.
• This project requires 2 individuals for proper safety and
practical installation Air conditioner body and remote
controller must be (39-3/4”) or more away from a TV or a
radio.
• Ensure proper ventilation and avoid anything that may
obstruct operation of the front of the indoor unit.
• Choose a place which can stand the weight of the unit and
does not increase the operation noise or vibration.
• Avoid areas where there may be vibration in the house, and
affix the unit by inserting / attaching vibration-proof pads
between the unit and fittings.
• Avoid leaving items near the outlet and inlet of the outdoor
unit. These can cause malfunction or increase operation
noise.
• Contact ClimateRight® Customer Service if you hear irregular
sounds during operation.
• Only use a soft, dry cloth to wipe the unit clean. If the unit is
especially dirty, you can use a cloth soaked in warm water to
wipe it clean
• Do not install the indoor unit on non-metal frame. Use
mounting bracket provided.
INSTALLATION
OF INDOOR UNIT
Before installing the indoor unit, refer to the label on the
product box to make sure that the model number of the indoor
unit matches the model number of the outdoor unit.
CHOOSE AN APPROPRIATE LOCATION
The following are standards that will help you choose an
appropriate location for the indoor unit.
Proper installation locations meet the following standards:
• Good air circulation.
• Convenient drainage.
• Noise from the unit will not disturb other people.
• Firm and solid—the location will not vibrate.
• Strong enough to support the weight of the unit.
• A location at least one meter from all other electrical devices
(e.g., TV, radio, computer).
INDOOR UNIT MINIMUM SPACE
REQUIREMENTS
(91" minimum for
ceilings over 9 ft)
Ceiling
Floor
4"
6"
6"
72"
Figure 1: Minimum space requirements for indoor unit
REQUIREMENTS FOR WALL MOUNT
INSTALLATION
• Wall mount must be level to ensure unit will function
properly.
• Screws should be placed in wall studs to ensure the mount
will support the weight of the indoor unit.
• Do not use any bracket other than the one provided.
• Make sure there are enough screws in the mount to support
the weight of the unit.
• If the wall is made of brick, concrete, or similar material, drill
5mm-diameter (0.2in-diameter) holes in the wall and insert
sleeve anchors. Then secure the mounting plate to the wall
by tightening the screws directly into the sleeve anchors.
