SPECIFICATIONS
Specifications
CRPH300
Voltage:
120V
Power cord:
8 feet with metal chew protection
Heating power:
300W / 2.5A
Heating element:
Ceramic Positive Temperature
Coefficient (PTC) / 100,000+
ON/OFF cycles
Fan:
13W / 120V / 60Hz / 0.11A /
30,000 hours
Decibels:
42
Air displacement:
Up to 30 cu ft per minute
Controls:
Manual ON/OFF
Heat settings:
OFF/LOW/MEDIUM/HIGH
Heat Low:
52–65 °F (11–18 °C)
Heat Medium:
66–81 °F (19–27 °C)
Heat High:
82–95 °F (28–35 °C)
Fan only:
Yes
Auto safety shut off*:
Yes
Enclosure material:
Powder-coated steel
Installation:
Wall mount
Enclosure size:
35 cu ft
Weight:
5.1 lbs
* The overheat sensor will automatically shut off the heating
element if it exceeds the high heat threshold temperature.
CONTENTS
• Pet Heater
• Installation template
• (4) Self-tapping wood screw, 4x30mm
• Owner’s Manual
TOOL REQUIRED
• Measuring tape
• Tape
• Drill
• 1 1/8 in. wood drill bit
• Screw driver
INSTALLATION
1.
If present, remove pet from pet house.
Note:
The pet heater must be mounted on a side wall. DO
NOT mount on the floor or ceiling.
2.
Place the template so that the power cord drill hole mark
is a minimum of 11 in. from the ceiling and 7 in. from either
wall. Tape the template in place.
PAPER TEMPLATE
TAPE
DRILL HOLE MARK
11"
7"
DRILL BIT
3.
Using a 1 1/8 in. wood drill bit, drill a hole at the template
drill hole mark and through the wall of the enclosure.
4.
Start the included self-tapping screws in the wall at the
marked locations on the template, remove, then remove
the template from the wall.
Note:
Depending on the enclosure wall material, you may
need to drill pilot holes for the screws.
2
