ClimateMaster ATC32U01 iGate, Installation Manual

Page: 5 / 16

5
AT C 3 2 U 0 1 C o m m u n i c a t i n g , P r o g r a m m a b l e T h e r m o s t a t - I O M
R e v. : 4 F e b . , 2 0 1 3
SERVICE INFORMATION
FAULT STATUS
TEMPERATURE STATUS
CLEAR FAULT HISTORY
SYSTEM STATUS
SELECT OPTION
PREVIOUS
1.4 DEMO MODE
Demo mode is designed to showcase heat pump
operation when the unit is connected to an above
ground water loop with the supply air being blown
directly over the water loop.
1.4.1 ENTER DEMO MODE
To enter Demo Mode, navigate to the Service
Information screen (Menu>Settings>Service
Information) then press and hold the right arrow for
5 seconds
1.4.2 DEMO MODE OPERATION
Control Demo Mode operation parameters from the
Demo Operation screen shown below.
DEMO OPERATION
OUTDOOR FAN AUTO
78% HEATING
RH 36% HUMID ON
72%
AUTO
SETPOINT
HEAT 70
COOL 74
RH TEMP MODE FAN MENU
The starting mode (heating or cooling) depends
on the loop temperature at the time when Demo
Mode is entered. The unit will operate in heating or
cooling based upon the following algorithm.
1.4.3 EXITING DEMO MODE
To exit demo mode, remove power to the
thermostat.
Start in Cooling Mode Start in Heating Mode
90°F
70°F
50°F
Solid lines represent heating operation. Dashed lines represent
cooling operation.