13
6- FAQs
PROBLEM
PROBABLE CAUSE
SOLUTION
The device does not
heat up
The device is in energy-
saving mode
Due to the thermal inertia, the device transfers
heat to the room; should you need more
temperature, increase the device temperature
The room does not
reach the desired
temperature
Incorrect setting of the set
temperature
Check the set temperature on the display to
verify it is the desired temperature.
Improper sizing
The power is not the adequate for the place in
which it has been installed
Excessive height
Make sure the system is installed at the
recommended height
Input and output grids are
obstructed
Do not place anything on top of the radiator and
do not install it inside a cavity wall.
The radiator does
not operate
Set temperature below room
temperature
Rise the radiator’s set temperature until it is 1
degree above the room temperature
Check that the automatic
control is not down. If it is
down put it up.
Check that the automatic control is not down. If
it is down put it up
Make sure the installation is correct and that
there are independent lines for the heating
system with a 2.5 mm2 cable gauge and a
maximum power of 3500 w
Switch it off
Set the switch in position I
Program is OFF
Check that the set program is the chosen one or
set the one you desire.
The radiator stains
the walls
Radiator located at a very low
height
The minimum height from the floor to the
radiator’s lower part must be at least 25 cm
Dust accumulation on the
wall
Vacuum it at the beginning of each heating
system
Type of painting on the wall
Paints with a high content in rutile are likely to
darken
Blocked buttons
No response from operating
buttons
Press buttons MODE and
for 3 seconds.
Summary of Contents for SILICIUM 3 IN 1
Page 1: ...USER S GUIDE SILICIUM 3 IN 1 ...
Page 2: ...2 ...
Page 5: ...5 Check dimensions and levelling before drilling Dimensions in mm ...
Page 15: ...15 ...
