3
For retrofitted to an existing heat pump
Before tightening nuts
3
and
4
, place the drainage tray
under the pump by slightly inclining the pump at the back
and in this way opening it up sufficiently with space to feed
in the tray from the front.
4
3
Mounting with the straight adapter
Mounting the adapter with LEAF basket
S t e p
D
– A s s e m b l y o f t h e a d a p t e r a n d ( o p t i o n a l )
d r a i n a g e k i t
Grommet
1.
Pull the heating cable through the tray adapter (mounted on tray).
2.
Pull the heating cable through the drainage hose (easiest with the
draw cable) and affix the hose to the tray adapter, then secure the hose
with the locking clamp. Attach the heating cable in the tray’s cable
support, as shown on the image.
1.
Pull the rubber grommet close to the thermostat of the heating cable.
2.
Pull the heating cable through the adapter’s bottom part.
Press the grommet into the adapter.
3.
Pull the heating cable through the drainage hose (easiest with the
draw cable) and affix the hose to the tray adapter, then secure the hose
with the locking clamp. Attach the heating cable in the tray’s cable
support, as shown on the image.
4.
Put the basket with gasket through the tray outlet.
Hold the adapter’s bottom part below the outlet and
steadily screw the two parts together.
