Installation Manual PA Pro III
online
–
2018-03-16 Page 21 of 30
8
Configuration of PA Pro III
The chapter describes the DIP-switches on the ClimaCheck PA Pro III and how to configure them. In
most cases the unit will be delivered pre-configured to fit the system, but changes in the setup
compared to the order may cause a need for change of these settings. For a full description please
refer to the hardware manual.
8.1
Change analog input mode (mA/V)
To change the analog inputs on the PA Pro III between current and voltage input, DIP-switches on
the back side of the unit are used, see Figure 6.
The red DIP-switch block to the right controls analog input 1 to 4 where OFF means voltage input
(0-10V) and ON means current input (0-20mA).
Figure 6 - Back side view
-
Pin
-
Position
-
Function
1
ON
OFF
Analog input 1 as current input
Analog input 1 as voltage input
2
ON
OFF
Analog input 2 as current input
Analog input 2 as voltage input
3
ON
OFF
Analog input 3 as current input
Analog input 3 as voltage input
4
ON
OFF
Analog input 4 as current input
Analog input 4 as voltage input
8.2
Change communication mode
To select communication mode between LAN, WLAN and mobile, DIP-switches 1 and 2 on the top
left side are used, see Figure 7.
