55
© 2 0 0 6 d i r e c t e d e l e c t r o n i c s
QUICK REFERENCE GUIDE
To arm using your LCD remote
➤
You can activate, or arm, the system by pressing
on your remote for one
second. When the system arms, you will hear a short siren sound, or chirp, and
the parking lights will flash once. If the vehicle’s power door locks have been
connected to the system, the doors will lock.
To disarm using your LCD remote
➤
To disarm the system, press
. You will hear two chirps, and the parking
lights will flash twice. If power locks are connected to the system, the doors will
unlock. If the siren chirps either four or five times when disarming, see
Diagnostics section. This is called Tamper Alert.
Arming while driving
➤
Press
on your remote for two second while the vehicle is running. The
system will chirp once and then once more to indicate that the ignition is on.
Disarming without a LCD remote
➤
Turn on the ignition. Press and release the Valet
®
button the programmed
number of times within 15 seconds. After five seconds, the system will disarm.
If it does not, you may have waited too long. Turn the ignition off and on and
try again.
To enter or exit Valet
®
Mode
➤
Turn ignition to RUN position, then turn to OFF position. Press and release
the Valet
®
button within 10 seconds. The in-vehicle status LED will light solid
if you are entering Valet
®
Mode, and it will go out if you are exiting Valet
®
Mode.
To activate Panic Mode
➤
Press and hold
or
down for approximately two seconds.
To exit Panic Mode
➤
Press
or
on the remote.
To activate Silent Mode™
➤
Press
briefly before arming or disarming, and the confirmation chirp(s)
will be eliminated for that one operation only.
Location of Valet
®
Button_______________________________
Number of Valet
®
Button pulses for disarming_____________
Cut along dotted line and f
old f
or a quick and eas
y
r
efer
ence to k
eep in y
our pur
se or w
allet.
✂✂
✂ ✂
