© 2004 directed electronics, inc.
11
immobilizer harness wire connection guide
immobilizer harness wiring diagram
___
___
___
immobilizer harness wiring guide
h2/1, h2/2, and h2/3 black immobilizer pigtail harness
The starter immobilizer harness can be installed as a normally open or normally
closed circuit by connecting the desired side of the three-wire immobilizer. Locate the
starter wire, then cut it and make connections as described in the following diagram.
Connect H2/1 to the end of the wire that is still connected to the ignition switch; con-
nect H2/2 or H2/3 to the end of the wire that continues to the vehicle’s starter circuit.
N
NO
OTTEE:: Factory settings is normally closed if wired for normally open you must change
the programming.
ON BOARD
IMMOBILIZER
NORMALLY OPEN (87)
NOT USED (87A)
COMMON (30)
NORMALLY
OPEN
NORMALLY
CLOSED
ON BOARD
IMMOBILIZER
NOT USED (87)
NORMALLY CLOSED (87A)
COMMON (30)
BLACK
Starter - Normally Open (Motorside)
BLACK
Starter - Normally Closed (Motorside)
BLACK
Starter - Common (Keyside)
H2/1
H2/2
H2/3
