25
© 2010 Directed Electronics. All rights reserved.
Remote Start Faults
For user safety, the system must be properly configured or remote
start will not activate. A Remote Start Fault may be caused by any of
several configuration issues. Refer to the table below for the command
type and parking light flashes that will identify the configuration issue
and solution.
Flashes *
Possible Fault
Solution
5
Brake on
Release foot brake
6
Hood open
Close hood
7
After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
Enable MTS mode
Check all Solutions
8
Toggle Switch off
Turn switch on
None
Alarm is triggered
Disarm or reset alarm
* Refers to the number of parking light flashes.
