Safety Instruction
WWW.CLF-LIGHTING.COM
2
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
The following symbols are used to identify important safety information on the product and in this manual:
DANGER!
Safety hazard.
Risk of severe
injury or death.
DANGER!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
Fire hazard.
WARNING!
LED light
emission. Risk of
eye injury.
WARNING!
Burn hazard. Hot
surface. Do not
touch.
WARNING!
Wear protective
eyewear.
WARNING!
Refer to user
manual.
Warning! Do not look into the beam at a distance of less than 2 meters from the front surface of the product. Do
not view the light output with optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock and falls.
Rea
d this manual before installing, powering or servicing the fixture, follow the safety precautions listed below and
observe all warnings in this manual and printed on the fixture. If you have questions about how to operate the fixture
safely, please contact your supplier.
PROTECTION FROM ELECTRIC SHOCK
•
Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
•
Always ground (earth) the fixture electrically.
•
Use o
nly a source of AC power that complies with local building and electrical codes and has both overload and
ground-fault (earth-fault) protection.
•
Befo
re using the fixture, check that all power distribution equipment and cables are in perfect condition and rated
for the current requirements of all connected devices.
•
Power
input and throughput cables must be rated 20 A minimum, have three conductors 1.5 mm² (16 AWG)
minimum conductor size and an outer cable diameter of 5 - 15 mm. Cables must be hard usage type (SJT or
equivalent) and heat-resistant to 90° C minimum.
•
Use
only PowerCON TRUE 1
®
cable connectors to connect to power input sockets. Use only PowerCON TRUE 1
®
cable connectors to connect to power through put sockets.
•
Isola
te the fixture from power immediately if the power plug or any seal, cover, cable, or other component is
damaged, defective, deformed, wet or showing signs of overheating. Do not reapply power until repairs have been
completed.
•
Refer
any service operation not described in this manual to a qualified technician.
•
Socket o
utlets used to supply fixture fixtures with power or external power switches must be located near the
fixtures and easily accessible so that the fixtures can easily be disconnected from power.