Setup
Warning! Read “Safety Information” on page 3 before installing, powering, operating or servicing
the fixture.
The onboard control panel and backlit graphic display are used to set the
's DMX address,
configure individual fixture settings (personality), read out data and execute service utilities. See “Onboard
control menus” on page 17 for a complete list of menus and commands.
Using the control buttons
l
To enter a menu, select a function or apply a selection, press
(Enter).
l
Press
(Up) and
(Down) to scroll within a menu or adjust values.
l
To escape a function or move back one level in the menu structure, press
(MODE).
l
The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned its own control channels.
The DMX address is configured using the DMX ADDRESS menu in the control panel.
Press
the
button
“
UP”
to
switch
off
Wireless
DMX
or
disconnect
with
all
connected
Transmitters
.
Press
the
button
“
DOWN'
to
set
the
unit
in
the
”ready
to
connect
with
all
not
connected
transmitters'
mode
.
If
you
press
the
mode
button
on
the
Wireless
solution
transmitter
all
the
ready
to
connect
units
will
be
connected
.
If
the
unit
is
successfully
connected
in
the
home
display
the
sign
“
”
.
Appears
.
If
the
unit
is
not
connected
to
a
transmitter
or
switched
off
no
“
”
.
sign
is
visible
fixture
►
▲
▼
◄
Holding down the "UP" or "DOWN" button for more than 3 seconds, the MENU display rotated 180°
l
In order to facilitate for inspection the signal, If the display to flicker when it's not receiving any signalNotes
Control panel and menu navigation
DMX address setting
WDMX control
11