CLF Colour Par 12, Manual, Page: 10 / 16

10
Operating instructions
1 Factory reset
SET
Ü
REST
Ü
{UP UP DOWN DOWN}
Ü
{ENTER}
Note: The password is permanently set as {UP UP DOWN DOWN}
Then press ENTER button
1 Custom program
EDIT Ü
PR01
Ü
PSC01
1
Press MENU button until
EDIT
is displayed, press ENTER access program mode.
2
Select the program you'll edit by pressing UP/DOWN buttons. The available
range is o1-10.
3
Select the step you'll edit by pressing UP/DOWN buttons, and then press
ENTER button access program.
When 'R000' display on the screen, press the UP/DOWN button to choose the value.
Repeat this step to edit the value of 'G000', 'b000', 'S000', 'T000' and 'F000'.
Please pay attention for the 'S' is the rate of strobe. 'T' is the operating time of the
present step, the value is between 0 to 255. 'F' is the transitional time from previous
step to present step. The transitional time is the quickest when the FADE is 0.
Notice: Please operate the program in turn, from the 01st step to the 30th step.
When the operating program less than 30 steps, please set the final step value be 0
4
Repeat step 3 till complete programming.
5
Exit program mode by pressing MENU buttons three times.
DMX512 Controller Mode
1 Setting DMX512 Address
DMX
Ü
001--512
Access control panel function by pressing MENU until DMX is displayed.
Press ENTER, add or reduce channels by pressing UP/DOWN between 001 and 512.
Press
MENU to exit.
2 Setting Channels
PERS Ü 03CH 04CH 05CH 06CH
Access control panel function by prekssing MODE until PERS is displayed.