WWW.CLF-LIGHTING.COM
7
physical installation
Warning! The machine must be either fastened to a flat surface such as a stage or wall, or clamped to a truss or
similar structure in any orientation using a rigging clamp.
Warning! At all times machine can cause injury or damage it if falls, attach an approved safety cable to one of the
safety cable attachment points on the base (see “machine overview” on page 4).
Check that all surfaces more far aways then a minimum of 200 mm. from the machine, that combustible materials
(wood, fabric, paper, etc.) are minimum 100 mm. from the nozzle, that there is free airflow around the machine
and that there are no flammable materials nearby.
Fastening the machine to a flat surface
The machine can be fastened to a fixed flat surface that is oriented at any angle. Check that the surface
can support at least 10 times the weight of all machines and equipment to be installed on it.
Warning! The supporting surface must be flat otherwise the air vents in the base may be blocked, which will cause
overheating. Fasten the machine securely. Do not place it on a surface or leave it where it can be moved or can fall
over. Attach a securely anchored safety cable to the safety cable attachment point (see “machine overview” on page.
If the machine is installed in any location where it may fall and cause injury or damage if the primary attachment
fails:
1.
Block access under the work area. Working from a stable platform.
2.
Secure the machine with a secondary attachment such as an approved safety cable that is rated for the
weight of the machine using one of the attachment points at the edges of the base (see “machine overview”
on page 4). Do not use any other part of the machine as a safety cable attachment point.
operating instructions
1.
After checking that all the parts are intact and complete, position the machine on a flat surface.
2.
Only use designated CLF Lighting smoke liquid. Machine can be harmed when using other fluids and warranty is expired.
3.
Connecting the power cord. Before power on, make sure it is connected with the rated voltage.
4.
Turn on the machine, it will immediately start heating up, the digital display will show “WARMING UP”.
Menu instruction
1.
MENU button: When it shows “HEAT”, press “menu” button to enter the page “ADDR”
2.
UP button: Increase the relevant value of each page
3.
DOWN button: Decrease the relevant value of each pag
4.
ENTER button: Enter or exit each page
Wireless Controll
When the wireless control function is activated, digital display will show as the above picture once the machine is powered on.
The line will increase gradually, and the digital display will exit this page till the line is full (12 lines). It takes 12 seconds to fulfill
this. During this time, press any button on the remote, the digital display will flash twice, this means that the wireless remote
matches with fog machine successfully. Users can control the machine by the wireless remote. Remark: There would be no
response for rematch.
One machine can match with five different frequency controllers at most (the process should be finished within 12s). If the
machine has matched with a controller last time, then in next time’s use, if user does not register it with another new remote,
it will recognize last time’s remote. While if the machine has matched with three controllers last time, and user matches it with
another new remote in next time’s use, it would only recognize the new remote rather than the old three.