Disassembly
Removing the Inverter Board 2 - 11
2.Disassembly
Removing the Inverter Board
1.
Turn
off
the computer, and remove the battery (
page 2 - 5
).
2.
Remove any rubber covers, screws
-
(
Figure 7
a
), then run your finger around the middle of the frame to
carefully unsnap the LCD front panel module
from the back.
3.
Discharge the remaining system power (see
Inverter Power Warning
below).
4.
Remove screw
(
Figure 7
b
) from the inverter, and carefully lift the inverter board up slightly.
5.
Disconnect cables
&
(
Figure 7
c
) from the inverter, then remove the inverter
(
Figure 7
d
) from the LCD
back cover module.
Figure 7
Inverter Board
Removal
a. Remove the 6 screws
and unsnap the LCD
front panel module from
the back.
b. Remove the screw and
discharge the remaining
power from the inverter
board and lift the board
up slightly.
c. Disconnect the cables
from the inverter.
d. Remove the inverter.
1
6
7
8
9
10
11
7. LCD Front Panel
11. Inverter Board
•
6 Screws
a.
b.
11
Inverter Power Warning
In order to prevent a short circuit when re-
moving the inverter it is necessary to dis-
charge any remaining system power. To do
so, press the computer’s power button for a
few seconds before disconnecting the in-
verter cable.
1
9
2
5
3
4
6
c.
d.
10
8
7
Summary of Contents for W760TH
