1
2
3
4
5
6
A
B
B 9
operation
(3) You installed a different hard disk with a
Save to Disk
partition on it or there has been a CMOS or Checksum
failure. You must run the
PhDisk
utility after one of the
above conditions.
The system never goes into
Suspend
mode.
possible cause:
Power management features are not enabled.
solution:
Go to the
Setup
s Power Savings menu and enable the
features you prefer. Refer to the Power Management sec-
tion of
Chapter 5: Power
.
The system does not go into
Suspend
or
Save to Disk
when the battery is low.
possible cause:
Suspend Timeout is disabled.
solution:
Use one of the Power Management presets or manually
set the Suspend Timeout in the Power Savings menu in
Setup
. Refer to
Chapter 4: Firmware
and
Chapter 5: Power
.
The PC Card does not work.
possible cause:
The drivers are not loaded.
indicator:
The system cannot access the card after it is installed.
solution:
Load the proper drivers.
Summary of Contents for 9800
