1948865
V1.1
18 March 2022
Installation:
The ARGO-1200-EM-xxx can be mounted to or suspended from any solid surface. Please follow the
below installation steps:
•
Determine the installation method (surface/surface with clips) and the power entry method.
•
Undo the diffuser clips, remove the diffuser and gear tray. Position the batten base in the desired
location. Mark out the fixing points on the mounting surface.
•
If the cable entry is to be via the rear of the body
– Drill out a suitable entry-hole in the rear of the
batten body (must be suitably sealed after cable entry using a sealant). If the cable entry is via the
end of the batten - Install the provided cable gland, or bring in conduit, to the base as required for
the intended power access. Note: Only round cables are to be used with the cable gland for an
IP65 seal. Keep cable entry straight and tension free. Ensure all seals are tight.
min. wire diameter 6mm, max. 12mm.
•
For surface mounting -
, there are 2 extrusions/posts at each end of the base. Drill out the desired
number of fixing points at each end.
Fixings must only be through the extrusions/mounting
posts.
o
Position the fitting to the mounting surface and mark the mounting holes.
o
Drill the mounting holes.
o
Fix the base to the surface with appropriate fixings.
o
Seal mounting area with appropriate sealant.
•
For Surface Mount Clip
mounting,
measure/mark spacing (see dimensions below),
install
stainless steel clips to surface (use appropriate fixings), then snap batten into clips.
•
Re-attach battery into Emergency Driver & remove Warning Label from Terminal Block.
•
Wire mains power cable, 240V 50Hz, to terminals marked Lsw (Switched Active), Lem
(Emergency/Unswitched Active), N &
•
Set LED Driver Power Output to either Low (2000Lm) or High(4000Lm) (non-MS-HL version only)
•
Set Colour Switch to the desired colour (3000K, 4000K, 5700K)
•
Attach gear tray to lanyards.
•
Reinstall the gear tray, diffuser and latch the diffuser clips.
Wiring:
Sensor Version:
Dimensions:
Driver Setting:
(non-SEN version only)
Colour Setting:
Gear Tray Clip:
Battery Replacement
1.
Prior to any work, isolate power to any Batten that requires battery replacement
2.
Open the Diffuser by releasing the Batten Diffuser Clips (remove any screws that may have been
installed into clips)
3.
Unlock the Gear Tray by rotating the Gear Tray Clips 90° in an anti-clockwise direction (ensure the
Gear Tray is supported while unlocking clips)
4.
Remove Battery connector from the Emergency Driver
5.
Remove Battery and Battery Clips from the Gear Tray (release one side of clips to remove battery
and clips together as one)
6.
Install replacement Battery & Clips and connect into Emergency Driver
7.
Re-Install the Gear Tray and ensure Clips are locked (rotate clips by 90° clockwise)
8.
Re-Install the Diffuser and close all clips (re-install any screws that may have been inserted into the
Diffuser Clips)
Note:
This luminaire (with reinforced insulation between control/LED terminal and AC Supply) contains non-
user replaceable light source and battery
– to be replaced (if required, refer installation instructions for
battery replacement) by the manufacturer or his service agent or a similar qualified person.
