WARNING - PLEASE READ CAREFULLY!
Do not operate the pump and heating system whilst the CleverSpa
®
is empty, as this may damage
the system and void your warranty.
10
INFLATE/BUBBLE
TEMPERATURE
FILTER
SETTING THE TEMPERATURE
To set the temperature, press the ‘Temperature’
button and the numbers on the display screen
will start to flash. You can increase and decrease
the temperature by pressing the ‘Temp Up’
or ‘Temp Down’ buttons.
When you have chosen your desired
temperature, press the ‘Temperature’ button
again to confirm. Temperatures can be set
between the range of
20°C to 42°C
.
FILTRATION SYSTEM
To use the filtration system, press the ‘Filter’
button, a red light will appear and the pump will
start to work. Press the ‘Filter’ button again once
to stop the pump, the red light will go out.
As a reminder to change your filter, after approx.
168 hours, the letters ‘FC’ will appear on the
display screen, accompanied by a warning tone.
The red light will still be lit on the ‘Filter’ button,
but the pump will not be operational.
The heating system will also not work and the
red light will also be out on the ‘Heater’ button.
To make sure the filtration system is actually off,
you need to press the ‘Filter’ button again. The
letters ‘FC’ on the display screen will disappear
as well as the warning tone. The actual water
temperature will be displayed, and all functions
will return to their normal working status. ‘FC’
and the warning tone are a reminder that the
user should replace the filter.
INFLATE/BUBBLE
Press the ‘Inflate/Bubble’ button and the bubble
jets will start working - a red light will also
appear. Press again and the bubble jets will
stop working and the red light will go out.
The bubble jets will stop automatically after
working for 20 minutes. To reset, please wait
for 10 minutes and then press the “bubble”
button again. The bubbles stop after
20 minutes to avoid over-heating of the internal
pump and is there as a safety measure.
During any time period where the bubbling
function has been started, bubbling can be
stopped or started.
HEATER
To start the heating system, press the ‘Heater’
button, a red light will appear. Press the ‘Heater’
button again once and the heating system will
stop and the red light will go out.
When you turn the heating system on, at
the same time the filter system will switch
on to circulate water automatically. When
the temperature has reached
1°C
above the
pre-set temperature the heating system will
stop working, but the heating indicator light
will remain lit. The filter pump will continue to
operate even when the heater is not functioning.
When the water falls
1°C
below the pre-set
temperature, the heating system will begin to
automatically heat the water back up to
1°C
above
the selected temperature. Once this is
achieved the heater will then stop to allow the
temperature to settle at the pre-set value.
HEATER
‘FILTER
CHANGE’
OPERATING YOUR CLEVERSPA
®
SS19 6 Person Square CleverSpa IM_AW.indd 10
30/10/2018 15:30
