Installation instructions
Step 1
: Assemble the tray first, insert two side-‐boards and
bottom board by inserting screws “A” into pre-‐drilled
sockets, and tighten with nuts “B” in a clockwise direction.
Step 2:
Insert the front board, using nuts “B, tightening in a
clockwise direction.
Step 3:
Turn the tray upside down, insert nuts “B” to
every screw hole, then tighten clockwise.
Step 4:
Assemble the changing unit
:
Insert screws “A” in each
pre-‐installed hole as shown below on each panel
Step 5:
Lay one side board flat and insert top board, bottom
board and backing board over the screws “A”.
Step 6:
Tighten all in clockwise direction with nuts ”B”
