10
PHOTOS
/
VIDEOS
/
INFORMATION
MOTORSCRUBBERCLEAN.COM
WATER TANK CONNECTION & PUMP
Check the water pipe underneath the
machine, find a straight run with space
around it and also before it goes into the
solenoid valve. Cut the pipe and insert T
fitting. Look for space inside the battery
compartment or underneath the chassis to
fit the pump and run the water pipe to the
T fitting.
The pump needs fitting into the plastic
battery compartment or steel chassis -
don’t screw into the tank
. If there is no
room in the battery compartment, try
underneath the machine. Ensure pump
cables and water pipe are securely fitted
and will not be damaged over time. Lift the
brush deck up and down and check the
pedal and brush deck is not moving near
any cables or the water pipe. Also check
squeegee bracket movement is not going
to affect the water pipe or cables.
Find the cable and water pipe entry point
into the battery compartment. Rear casing
or handle assemblies often have entry
points you can also drill through switch
plates, as shown, for access.
Force
Pump 24v
Solenoid
Valve
To Force Hose
Scrubber Dryer
Water Tank
Filter Fitted as Standard
Cut water pipe before solenoid valve, insert ‘T’ fitting
Inline Filter
Internal
Diameter
6mm
Check internal
diameter of this
hose and order T
fitting with 1 or
2mm larger barb.
PUMP FITTING DIAGRAM
Summary of Contents for MotorScrubber Force
Page 17: ...Pump 24 Volt Total 12 V 12 V Force cable FORCE KIT WIRING DIAGRAM...
Page 20: ......
Page 21: ......