Cleco MA3S358M, Instruction Manual

Page: 14 / 36

Page 14
PL70-1046EN
07/08/2013
Cleco
®
First Operation
6 First operation
6.1 Putting into use
The MA3 series motors are a five cylinder radial piston type. This radial design, with it’s overlap of
power impulses, provides even torque at all speeds and full power in either direction of rotation. At least
two pistons are always on a power stroke.
These motors are designed for continuous service on 60-100 PSI air pressure. If overloaded beyond
their power capacity, the motor will simply stall without causing any damage.
Ú
Make sure the air line is clean and free of scale and dirt before connecting to the motor.
Ú
Make sure all pipe fittings are securely tightened to prevent air leaks.
Ú
Make sure the air supply is securely attached and the compressor is turned on.
Ú
Make sure the output spindle is properly engaged with the application.
Ú
Make sure all necessary guards are in place to protect operator from rotating mechanisms.
Continuous Operation: Do not operate the MA3 motors faster than 65% of free speed. Install a fil-
ter/lubricator unit in the air line as close as possible to the MA2 motor.
Intermittent Operation: The splash lubrication from the motor case will be adequate.
If an excessive amount of water is found in the air line, a water trap should be installed to trap as
much as possible before it reaches the MA3 motor.