Page 10
Step 3: Clearwater Speaker Installation
• Insert one of the supplied screws through the frame and the top hole
of the water shield.
• Insert the door speaker and water-shield into the door and loosely
secure the top screw into place.
Make sure that the wires do not get
pinched between the woofer and door.
• Using the screwdriver and the three remaining supplied screws,
gradually tighten each screw making sure the speaker goes in straight.
Be careful not to slip with the screwdriver, this could seriously
damage the door speaker.
Custom Tweeter:
• Place the custom tweeter into the tweeter hole on the rear of the door
panel and attach with the factory screws.
• Connect the wires from the tweeter to the wires labeled “tweeter” from
the sound module. (Connect the red wire to the red wire, and the black
wire to black wire)
Testing:
• Before completely re-installing the door panel, verify the tweeter
wires are connected together and turn on the radio to confirm that all
connections are secure.
• If there is no sound from the tweeter, re-check the tweeter wire
connections.
• If there is no sound from the woofer, re-check the woofer wire
connections.
• If there is no sound from either, re-check the input wire connections.
