Page 6
Step 3: Testing, Re-assembly & Product Specs.
improve access to the hole in the seat.)
• Attach the Red and Black wires to each of the “right” speakers and the
Gray and Green wires to each of the “left” speakers in each seat.
• Gently spread the headrest foam apart and press into place each of
the Clearwater speakers.
• Screws are not used to mount the speakers, the foam will hold them in
place.
• Position the white perforated plastic cover in place and zip the headrest.
• Check all connections.
• Turn down volume on radio.
• Turn ignition key to the Accessory position.
• Check operation of system.
Re-installation of Radio:
• Re-install radio. (HINT: When installing radio, check alignment of rear
support tab on back of radio to hole in metal frame.) Do not forget to
attach the hazard light / headlight raising switch connector!
• Re-install center dash face plate, eyeball vents, console and shift knob.
Wiring Instructions for Non-Factory Radio or Amp:
• Connect the amp left hot (+, green wire) to the hot (+) on the driver’s
left speaker.
• Wire between left driver ground and left passenger hot loops back
toward amp.
• Connect the amp left ground (-, grey wire) to the passenger left ground.
• Connect the amp right hot (+, red wire) to the hot (+) on the driver’s
right speaker.
• Wire between right driver ground and right passenger hot loops back
toward amp.
• Connect the amp right ground (black wire) to the passenger right ground.