Electrical:
•
Main power needs to be connected to a SWITCHED
HOT. This means one that turns off with the key. An
Auxiliary hot is an alternative. Using the supplied Posi-
twist connectors, connect the wires according to the ac-
companying color wire diagram. Attach ground lug to
ground on frame tab or other suitable location.
•
Use posi-twist to connect red from fuse holder to red
wires from lights and pot (4 wires)
•
Connect ground/black wire to black wires from lights
and pot (4 wires)
•
Connect the Blue wire from pot to the blue wires from
the lights (3 wires)
•
Connect the white wire from the pot to the high beam
headlight hot wire with a positap if you would like to
use the high beam feature.
•
DO NOT CONNECT BLUE WIRES TO 12 volts +.
You will damage the lights.
Wire routing
:
•
Be sure to route wires so that the cannot become tangled
or caught in either a suspension part or steering part.
Check movement of both steering and suspension before
riding the bike.
•
It is sometimes helpful to follow existing wire routing.
High Beam Feature
•
Our lights come with a feature that makes them flash to
full power when you activate the high beam headlight. If
you would like to use this feature (recommended), fol-
low these instructions.
•
Locate the HIGH BEAM headlight wire. This will be on
ONLY when the high beam is illuminated. This will
trigger our pot to control the brightness of the lights.
Connect the WHITE wire from the pot to this HIGH
BEAM circuit wire. See wiring diagram on following
page for details.
Summary of Contents for Glenda
Page 4: ......
