3
6
OFF ON ON OFF OFF OFF OFF OFF
7
ON ON ON OFF OFF OFF OFF OFF
8
OFF OFF OFF ON OFF OFF OFF OFF
…… …………………………………………………………………
254 OFF ON ON ON ON ON ON ON
255 ON ON ON ON ON ON ON ON
1.4
Reset and SD Card Installation (For IP Speed dome only)
You can see there are a RESET button, dial switch button and Micro-SD card on one side of the
PCB of the speed dome. See Figure 1-1 . It is 1 when you set the button as ON.RESET button is
to restore factory default setup. Micro-SD card is to save the data.
You can refer to the sheet for dial switch information.
1 2 ON
OFF
120
Ω
NC
Connect to 120
Ω
Figure 1-2
1.5
Installation (For Analog and IP Speed Dome Both)
1.5.1 Overview
The speed dome has various brackets suitable for different environments. For detailed
information, please refer to chapter 2 and chapter 4. Here we are going to install the analog
speed dome with the wall mount bracket.
1.5.2 Installation Conditions
Wall mount bracket is for the indoor and outdoor hard wall construction environments.
Before the installation, please make sure the wall thickness can sustain the expansion bolt. The
wall can support at least the 4X of the speed dome weight.
1.5.3 Dig holes
Draw the installation holes in the wall according to the holes at the bottom of the wall mount
bracket. Dig the installation holes. Insert the expansion bolts into the holes. (Please note the
expansion bolts are not included in the accessories bag.). See Figure 1-3.
1
2
3
4
ON
OFF
1. RESET button and dial switch label
2. RESET button.
3. Dial switch on-off button
4. Micro-SD card
Summary of Contents for IPPTZ-EL2MPIR250L30X-E
Page 1: ...IPPTZ EL2MPIR250L30X E Installation Manual Version 1 0 ...
Page 19: ...11 Figure 3 3 ...
Page 21: ...13 Figure 4 3 ...
