11
Revision date: 05.28.10
Corrugated Double Swinging Doors
Install sections of the horizontal closure strips (104709)
6.
under the panel
before
attaching the panel to the door
frame.
Trim closure strips as needed.
Drive Tek screws and washers through the panel,
7.
closure strip, and into the frame every 6" or so.
Install
Tek screws and washers in the valleys of the panel.
Screws should be snug. Do not overtighten screws.
Attach the panel in the locations as shown to hold
8.
the panel in place. If needed, secure the sides of the
polycarbonate panel to the door frame using Tek screws
only every 16".
Attach the
9.
door latch guide
to the door frame using the
remaining 1/4" bolts. Trim the edge of the corrugated
panel as needed to allow free movement of latch.
Repeat the required steps needed to assemble the
10.
remaining door frame and installation of the panel.
With assistance, set the assembled doors in the end
11.
wall door frame and secure hinges to the door jamb
using one Tek screw per hinge at this time
.
NoTe:
Verify that there is sufficient clearance along
all door edges to allow the doors to swing freely in the
opening.
If end panels are installed, loosen the panels,
secure the hinges directly to the door jamb, and reinstall
panel fasteners.
Test the operation of the doors, adjust hinges as
12.
needed, and install the remaining Tek screws to secure
hinges.
DoubLe CoRRuGATeD DooR ASSeMbLY (continued)
Tek Screw
and Washer
Valley
Closure Strip
STEP 6
STEP 8
104709 strip
Horizontal
Position
Door Latch
Guide
Latching
Plate
STEP 11
Closure Strip
Closure Strip
STEP 13
STEP 9
Trim corrugated panel as needed
to install the door latch guide.
Horizontal
Position
Door Latch
Guide
Latching
Plate
STEP 7
Closure Strip
