17
Revision date: 07.03.14
CLEARSPAN
™
PREMIUM MOO-TELS
INSTALL POLY LATCH U-CHANNEL
Gather the parts:
• Aluminum U-Channel (#102197)
• Ribbon board - 2" x 6" or 2" x 4" (see drop-down
curtain)
• Tek screws (#FA4482B) & 1/4" x 4" carriage bolts
1. Attach one section of the poly latch U-channel to the
ribbon board using Tek screws. Attach U-channel flush
with the outside edge of the end wall panels.
Space
Tek screws at 16" on-center.
2. Continue to attach the U-channel sections to the ribbon
board and work toward the other end of the frame.
Ribbon Board
Rafter
Rafter
2" x 6" or 2" x 4"
Board
1" x 4" Board
(Installed later in
these instructions)
1/4" x 4"
Carriage
Bolts
U-Channel
Side View
MAIN COVER INSTALLATION
After installing the end panels, install the main cover. The
steps to install the cover include:
1. Attach poly latch U-channel along the Moo-Tel sides
and tops of the Moo-Tel
end rafters
.
2. Pull the cover film over the frame and attach to the end
rafters.
3. Stretch and attach the cover to the sides.
ROLL-UP PANEL INSTALLATION (continued)
4. Use the pipe diagrams on the End Framing Details
diagram to assemble the crank up assembly.
5. Secure each splice using a Tek screw and cover the
Tek screw with duct tape to protect the panel pocket.
6. Insert the assembly into the panel pocket. Verify that
the assembly runs between the guide post and the
wooden support posts. Allow a few inches to extend
beyond the panel opposite the crank handle to keep
the conduit in place during operation.
7. With the assembly in the proper position, flip up the
skirt at the bottom of the panel to secure the conduit to
the end panel using the CC6212 fabric clips and Tek
screws. Divide the clips evenly between the panels and
space them evenly along each conduit.
8. Cut a vertical slice in the panel skirt to fit around the
lower guide post assembly bracket. Do not cut through
the end panel.
9. Test the roll-up panel.
NOTE:
Verify that the 3/8" threaded rod that secures
the customer-supplied end frame to the end rafter is
sunk below the post surface (recommended) or has
been cut off and taped to protect the panel.
10. Repeat the steps for the remaining panel.
11. After installing the door hardware and brackets, attach
the end panel material to the end frame and end rafter.
END PANEL INSTALLATION (DCC4931)
Consult the End Panel Location and Door Frame Panel
Location diagrams at the back of this manual to view the
areas that need to be covered with end panel material. Use
these steps to cut and attach the end panel material to the
end wall frame.
1. Measure the area of the end wall that needs to be
covered with end panels and cut a section from the
bulk material. Allow extra material to achieve best fit.
NOTE:
Due to differences in construction methods and
customer-supplied support materials, the customer
determines the best way to prepare the bulk material
for installation.
2. Set the prepared end panel in place and attach it to
the end frame using wood screws and neo-bonded
washers. Attach it to the rafter using Tek screws and
neo-bonded washers (102921).
3. Repeat the steps to cut and attach the remaining end
panels to cover the remaining end wall.
4. Repeat these steps to cut and attach the door frame
panels.
5. After installing all end panel and door frame panel
sections, install the main cover.
