CLEARSPAN
™
GARAGES & STORAGE SHEDS
14
Revision date: 06.11.08
INSTALL ROLL-UP CRANK ASSEMBLY
Gather the Parts:
• Pipe 1.315" x 75" Swaged (2)
• Pipe 1.315" x 49.5" Plain (2)
• Zipper Extension Pole (#CC2235)
• Spin Handle
• Universal Joint
• Fabric Clips (#CC6212) (4-6)
Assembly Procedure:
1. Assemble the roll-up door conduit by connecting one
(1) 75" swaged pipe to the 49.5" plain pipe, secure the
joint using a Tek screw, and tape over the Tek screw to
protect the end panel.
2. Insert the conduit assembly into the door pocket. When
installed correctly, the conduit is flush at one end of the
roll-up panel and will extend an inch or so beyond the
other end of the panel where the crank will be attached.
3. Secure the conduit to the panel using fabric clips as
shown below.
4. Attach the universal joint to the conduit in the pocket
using a Tek screw to secure the connection.
5. To assemble the extension pipe, connect the remaining
49.5" plain pipe and 75" swaged pipe and secure the
joint using a Tek screw.
6. Secure the extension pipe to the remaining end of the
universal joint using a Tek screw.
NOTE:
The extension pipe can be trimmed to the
desired length if needed.
7. Add the spin handle to the extension pole and secure
the connection with a Tek screw.
The roll-up crank assembly is now complete and is
shown below. Extension pipe may differ in length.
NOTE:
Use the zipper extension pole to zip and un-zip
tall zipper doors.
Do not open the door panel until the shelter is
completely assembled and anchored.