25
CLEARSPAN
™
GREENHOUSES
Revision date: 07.22.11
ASSEMBLE THE SLIDING DOOR
After attaching the rollers to the top of the doors, install
1.
the corrugated polycarbonate panel on the doors using
Tek screws (#FA4482) and washers (#102921).
NOTE:
The horizontal closure strips are used under
the panels along the edges to seal the corrugated
openings when the panels are installed with the ribs in
the horizontal position as shown in the photo (right).
Each door is covered using one 50" x 8' 2" panel.
DO
NOT
cut 12' panels to cover the doors.
Install the 104548 profile along the end wall door frame
2.
as shown in the following photos.
ATTENTION:
The installation of the 104548 profile is
an optional step for those who want to cap the end of
the corrugated end panels at the door opening. Use
Tek screws to secure the profile to the end wall framing.
Photo below shows end wall without installed profile.
Dashed line shows where to install profile to cover
the valleys of corrugated end panels.
View is from the
inside of the frame
looking at the point where the door
meets the door frame of the end wall.
Door
End Wall
Frame Tube
Photo below shows the assembled doors and the
corrugated polycarbonate panels.
Using the lower roller assembly as a guide, place one
3.
assembled door into position and rest its bottom edge
on the lower roller assembly as shown below.
Stay Roller
Adjust Stay Roller
as needed.
Door
Frame
End
Wall
Frame
Side view of the
door showing the
door frame and
stay roller.
With the first door in position, use blocks to level the
4.
door and set the second assembled door in place.
Level the second door and temporarily secure both
5.
doors in place so they do not tip to the inside or outside
of the greenhouse.
Using the rollers as guides, mark the location on the
6.
end wall for the sliding door track.
NOTE:
Be sure to account for the distance between the
top of the door frame and the roller assembly. you must
be able to adjust the door (up or down) once the track
is installed so that the doors are centered in the rough
door opening.
Use the lower roller assembly as a guide.
The final
adjustment for the door will lift the door 1/4" to 1/2" off
the angled brackets of the lower roller assemblies.
ASSEMBLE AND ATTACH SLIDING DOORS (continued)
