9
CLEARSPAN
™
VALUE LINE
Revision date: 10.05.10
INTERIOR RAFTER ASSEMBLIES
Gather the parts:
• Rafter pipe (#29R23S1D)
• Rafter pipe (#30R23S1) & rafter pipe (#30R23P2)
• Rafter foot (#104302)
&
Tek screws (#FA4482B)
• FAG363B 3/8" x 3" bolt and FALB04B 3/8" nut
• QH1065 Ratchets
Assemble Interior Rafters With Attached Ratchets
1. Repeat Steps 1 and 2 from the End Rafter Assembly procedure on the previous page.
2. Attach a ratchet (QH1065) and rafter foot to each leg of the rafter using a 3/8" x 3" bolt and 3/8" nut. Secure the
ratchet and foot using the same bolt and nut as shown
.
Ratchets can be attached to either the inside (not shown) or
the outside (shown) of the rafter.
If installed on the
inside of the rafter leg
, position the bolt head to the outside of the
rafter to prevent cover damage when it is installed.
3. Repeat the steps to assemble the remaining interior rafters that include QH1065 ratchets. Consult the Side Profile
Diagram in the Quick Start Guide near the back of these instructions to view the position and number of
interior rafters
with ratchets.
Do not use the QH1061 ratchets during this procedure; use only the remaining QH1065 ratchets.
29R23S1D
29R23S1D
104302
3/8"
Nut
3/8" x 3"
Bolt
QH1065
Outside of
shelter
Step 2
Ratchet
attach to the
outside of
shelter.
ATTENTION:
After assembling these interior rafters with
attached ratchets, set them aside in an accessible place.
Consult the Side Profile Diagram in the Quick Start
section during the frame assembly to set each rafter in
the correct position.
Do not place other assembled interior rafters from the
next procedure on the same rafter pile.
Diagram shows position of the
cross connector.
Cross connectors
are installed during the frame
assembly.
30R23S1
30R23P2
