15)
Cover all Screw heads with the Screw Caps
16)
Slide the outside Clamp Block Covers off the Pivot Clamp. Using a flat blade screwdriver sufficiently loos-
en the two screws, adjust the door by sliding le or right in the pivot
Once the door adjustment is complete ensure the screws are re ghtened and reinstall the Clamp Block
Covers. Open the door and remove the door se ng block
Notch under Door Magnet profile
18)
Fit the Drip Seals to the
glass door
14) Secure
in place using the 6 gauge x 10mm
screws.
Adjust the Door
Drip Seals
17)
The Drip seal is supplied in a 1m length, this will need to be
cut to the desired lengths for each side of the pivot . The open-
ing side Drip seal will also need to be notched to fit under the
door magnet profile. Make the Notch 13mm in length and fin-
ishing down to the horizontal ledge of the drip seal
NOTE: The flexible ver cal blade will face towards the inside
of the shower
