Installa on
Note:
Your shower Door can be installed to open from the le or right hand
side by rota ng the door 180 degrees, and the Return Panel can be
fi ed on either side. You must decide which way the door is to open be-
fore star ng the installa on.
3) Pre drill three equally spaced clearance
holes (i.e. top, bo om and centre) in
the Door Wall Receiver using a 4.5mm
drill bit. Reposi on the Wall Receiver
to the pencil line on the wall. Drill into
the wall through the clearance holes
using the 3.0mm drill bit. N.B. The
holes preferably locate into a stud or
nog. As an alterna ve, a toggle system
can also be used.
4
)
Secure the Wall Receiver to the wall using the
No.6 x 38mm stainless steel screws
NB As a precau on apply silicone sealant into the
drilled holes
1)
Determine which side the Door is
to be hung. Posi on one of the
Door Wall Receivers hard against
the inside edge of the tray up-
stand.
NOTE: If the shower walls
are to be tiled the Wall Re-
ceivers must be installed to
the Water proof membrane
before tiling. This ensures
the doors will fit within the
lip of the tray
2)
P
lumb up the Door Wall
Receiver using a spirit
level. Mark the posi on
with a pencil line.
Wall Receivers
5
) Fit the handle to the door (where required).
This will assist in the opening & closing during
the installa on process
Ensure to fit the plas c washers and bush to
prevent metal on glass contact
