Direct: 763.476.6866 • National: 800.422.2537 • www.SeeClearfield.com • [email protected]
10
FieldShield & FieldShield Flexdrop
Installation Manual
_________________________________________________________
Manual 018956 REV A- July 2017
Step 1:
Remove the white protective dust cap from the
unassembled connector
(Figure 1)
.
Note:
The SC Pushable Connector has a keyed locking
feature that holds the inner housing to the connector and
aligns the ferrule when the two are correctly mated.
To properly mate the connector, the key on the inner housing
must bypass the ferrule alignment notch to properly lock into
place.
Figure 1
Step 3:
Rotate counter-clockwise 45 degrees to realign the
inner housing and connector and push the inner housing onto
the connector until it snaps into place
(Figure 3)
.
Step 2:
Align the black mark on the inner housing with the
black line on the connector, then rotate the inner housing
45 degrees to offset the lock
(Figure 2)
and slide the inner
housing half way over the connector.
SC Pushable Connector
Housing Assembly
Figure 2
Figure 3
Figure 4
Figure 5
Step 5:
Re-install the white protective dust cap
(Figure 5)
.
Step 4:
Align the key on the outer housing with the black line
on the connector, then slide the outer housing over the entire
assembly until it snaps into place
(Figure 4)
.
