ClearCube M2010S, User Manual

Page: 48 / 142

5-16
C
lear
C
ube M2010S User's Guide
Wake-On-LAN
The Wake-On-LAN header is desig-
nated JWOL on the serverboard. See
the table on the right for pin defini -
tions. You must also have a LAN card
with a Wake-On-LAN connector and
cable to use this feature.
Chassis Intrusion
The Chassis Intrusion header is des-
ignated JL1. Attach an appropriate
cable from the chassis to inform you
of a chassis intrusion when the chas-
sis is opened
Chassis Intrusion
Pin Definitions (JL1)
Pin# Definition
1 Intrusion Input
2 Ground
Wake-On-LAN
Pin Definitions
(JWOL)
Pin# Definition
1 +5V Standby
2 Ground
3 Wake-up
LAN1/2 (Ethernet Ports)
Two Ethernet ports (designated LAN1
and LAN2) are located beside the VGA
port on the I/O backplane. These ports
accept RJ45 type cables.
Wake-On-Ring
The Wake-On-Ring header is desig-
nated JWOR. This function allows your
computer to receive and be "awak-
ened" by an incoming call when in the
suspend state. See the table on the
right for pin definitions. You must also
have a WOR card and cable to use
this feature.
Wake-On-Ring
Pin Definitions
(JWOR)
Pin# Definition
1 Ground (Black)
2 Wake-up
Power Supply Fail LED
Connect a cable from your power sup-
ply to JP3 to provide warning of power
supply failure. This warning signal is
passed through the PWR_LED pin
to indicate of a power failure on the
chassis. See the table on the right for
pin definitions. Note: This feature is only available when
using redundant power supplies.
PWR Supply Fail LED
Pin Definitions (JP3)
Pin# Definition
1 PWR 1: Fail
2 PWR 2: Fail
3 PWR 3: Fail
4 Signal: Alarm Reset