Clearblue Fertility Monitor, Instruction Booklet

Page: 28 / 48

8
26
Test error
The Monitor will switch off.
Replace the batteries immediately
to avoid losing your data.
The test inserted cannot be identified.
Symbols and Errors: Practical Advice
8
You have used a Test
Stick that cannot be
identified by the
Monitor. Test again
making sure you use a
Clearblue® Fertility
Monitor Fertility
Test Stick.
The message bar is
highlighted in red.
If you enter incorrect
information, or you do
not enter any
information but press
OK, the information bar
will be highlighted in red
to indicate this error.
Enter the correct
information.
The batteries are low and should
be replaced. If you delay you
may find you have insufficient
battery life and you could lose
your information. Leave the
batteries in your Monitor until you
are ready to replace them. Switch
the Monitor off and only remove
the batteries when you are ready
to replace them. Once you have
inserted new batteries you must
switch on your Monitor to allow it
to do necessary checks.
You will need to replace the
batteries before you can test.
The Monitor will switch itself off to
protect stored information. Do not
remove the batteries until you are
ready to replace them. Once you
have inserted new batteries you
must switch on your Monitor to
allow it to do necessary checks.