Performance
Instruction manual
Page 16
©
clearaudio electronic GmbH 2007
The middle groove is used for the exact speed. The upper groove increases the
speed a little bit, the lower groove reduces the speed a little.
Important:
Turn the platter now by hand, to ensure the perfect positioning of the belt around the
platter.
5 Azimuth-setting
Please note that the azimuth is pre-set exactly. If for any reason the azimuth must be altered
to compensate the geometry of some pick-up/cartridges, follow these steps:
loosen the screw on the bottom side of the tone arm near the headshell. Now you can adjust
the azimuth by turning the headshell gently in the tonearm. When finished, lock the screw
again.
33 1/3 ++
33 1/3
33 1/3 --
45 ++
45
45 --
