User manual / Bedienungsanleitung
Made in Germany
Page / Seite 15
3.2 Adjustment of the Antiskating
alignment of the antiskating
tracking force
posiion of the antiskating screw
minimal antiskating
10 - 15 mN
see illustration 1
medium antiskating
15 - 20 mN
see illustration 2
maximum antiskating
20 mN and more
see illustration 3
Illustration 1 :
Minimal antiskating
(Screw is almost
removed)
Illustration 2 :
Medium antiskating
(Screw is at half
position)
Illustration 3 :
Maximum
antiskating
(Screw is screwed
in)
3.3 Setting-up of the motor
Take the motor-pulley out of the accessory bag and shift the motor
pulley as far as on the motors shaft until you have a distance of
approximately 1 mm between the upper edge of the motor and
the lower edge of the pulley.
Now tighten the three screws in the pulley one after the other
with the precision screw driver.
Now place the motor unit into the stainless steel motor stand and fix the motor with the two screws
on the side of the motor stand. Place the motor unit into the cut out on the left side of the turntable
chassis and pay attention, that the switch of the motor faces outside.
Now you can connect the power cord to your power outlet.
Place one drive belt around the platter and
around the pulley.
The smaller diameter of the pulley is used for
33 1/3 rpm and the larger diameter for 45 rpm.
The position „I” on the motor-switches the
motor on.
Before first use, let the turntable run in for the first 15 to 30 minutes.
1 mm
Pic. 11: Antiskating adjustment
Pic. 12: Mounting the pulley
Pic. 13: Drive belt mounting
