User manual / Bedienungsanleitung
Made in Germany
Page / Seite 5
1. Installation and set-up
Before you begin, make sure that the tonearm is correctly installed on your turntable and is equipped
with the Clearaudio
absolute phono
headshell and Clearaudio
Direct Silver Wire with the special
9–pin connector.
To proceed with installation and set-up, please see the rear panel of your Clearaudio
absolute
phono
.
Rear view:
Please proceed as follows:
1. Connect the special 9-pin connector from the tonearm to the input marked “input amplifier”
and gently secure with the two locking screws. Please make sure that the screws are
properly tightened and thus the plug is securely connected.
2.
Plug the RCA or XLR cable into the output sockets and connect them to your linestage
preamplifier.
3. Connect the power supply provided to the socket marked “DC in”, “6V”, then connect this
power supply to your mains power supply.
4. Connect the power supply to the main power and switch the button to “I”.
Important: Please note that you may only use power supplies with a voltage of
6V DC!
1
2
2
3
4
Pic. 1:
Rear view
