Clear-Com Eclipse Median, Instruction Manual

Page: 46 / 114

Vitec Group Communications
Eclipse Median Instruction Manual
3 - 6
Each fiber card has two fiber transceivers with Duplex LC type
connectors. The TX1/RX1 connector is used for the main ring and the
TX2/RX2 connector is used for the secondary ring. Single mode
9/125µ fiber optic cable should be used for connections and the
matrices should be wired up with the system with the lowest I/P
address being system 1.
The fiber optic cable for the primary and secondary circuits are
plugged into the appropriate ports. An example showing three
systems configured with a primary and secondary ring is shown in
Figure 3-3.
Figure 3-3: Example Fiber Ring Setup
Eye Safety
This laser based single mode transceiver is a Class 1 product. It
complies with IEC 60825-1/A2:2001 and FDA performance
standards for laser products (21 CFR 1040.10 and 1040.11) except
for deviations pursuant to Laser Notice 50, dated July 26, 2001.
Note: The order of the fiber optic cable connections is reversed
between the front and rear panels. On the front panel the