EN
16
Filling the Fresh Water Container
PLEASE NOTE!
■
Never operate the device without water.
■
Only ever pour the cleaning agent supplied with the device or standard carpet clean-
ing products for carpet cleaners into the fresh water container.
■
Do not use any cleaning products that produce a lot of foam as excessive foaming
impedes the functioning of the device.
1. Pull up the release button (
4
) on the fresh water container (
5
) and take it out (
Pic-
ture D
).
2. Undo the lock nut on the bottom of the fresh water container and pull out the valve
(
Picture E
).
3. Fill the fresh water container with warm water (max. 2.5 l at max. 40°C) (
Picture F
).
The
MAX
marking must not be exceeded when the fresh water container is inserted.
4. Reinsert the valve and seal the fresh water container shut with the lock nut. 1
5. Insert the fresh water container into the back of the basic unit (
Picture C
). It must
click into place audibly.
Use
PLEASE NOTE!
■
Do
not
use the device like a conventional vacuum cleaner.
■
Make sure that the device does not tip over. The water from the water containers
could leak out.
■
After use, place the device down on a cloth as residual water may escape from the
nozzles after it has been switched off.
■
Do not wet the carpet excessively.
1. Decide where cleaning will start where you will stop without treading on the section of
carpet that has just been cleaned. We recommend that right-handed people should
start at the right-hand edge of the carpet, and left-handed people should start at the
left-hand edge of the carpet.
2. Turn the hooks for winding up the cable (
3
) towards each other (
Picture G
) and fully
unwind the connecting cable.
3. Clamp the mains cable into the cable mount (
2
) and plug the mains plug into an easily
accessible plug socket.
4. Press the On / Off switch (
6
) once to switch on the device.
5. Step on the pedal (
7
) (
Picture H
) and tilt the handle backwards into a comfortable
position.
6. Roll the device to a corner of the carpet.
7. Slide the device forwards along the edge of the carpet and hold down the button for
dispensing the cleaning solution (
1
). This applies the solution to the carpet and brush-
es it in. Walk to the side of the device as you do this.
Do not tread on the wet carpet!
Once you have reached the other end of the carpet, let go of the button.
