CleanCraft 7103662, Operating Instructions Manual

Page: 11 / 22

Operation
HDR-K Series | Version 1.03 11
9 Operation
9.1 Switch on, switch off, restart
Switch on
Step 1: Turn on the water supply tap fully.
Step 2: When mounted on the trolley, the trolley must be
in the upright position (Fig.8).
Fig. 8: Working position
Step 3: Release the safety catch (Pos. D, Fig. 9).
Step 4: Depress the gun trigger for a few seconds.
Step 5: Start the motor according to the operating in-
structions of the motor manufacturer.
Fig. 9: Unlocking the spray gun
Switch off
Step 1: Press the regulator lever at the engine to "STOP"
till the engine comes to a halt and turn off the
fuel tap.
Step 2: Depress the gun trigger and discharge the resi-
dual pressure inside the pipes.
Step 3: Engage the safety catch (Pos. D, Fig. 9).
Restart
Step 1: Release the safety catch (Pos. D, Fig. 9).
Step 2: Depress the gun trigger and discharge the resi-
dual air inside the pipes.
Step 3: Start the motor according to the operating in-
structions of the motor manufacturer.
9.2 Decommissioning
Step 1: Close the water supply tap.
Step 2: Release the residual pressure from the gun until
all the water has escaped from the machine.
Step 3: Press the control lever on the motor to "STOP"
until the motor stops and close the fuel tap.
Step 4: Disconnect the spark plug connector.
Step 5: Empty and wash the detergent tank after work.
Use clean water instead of detergent to wash
the tank.
Step 6: Actuate the gun lock.
ATTENTION!
Check oil level. If necessary, fill up with oil!
ATTENTION!
For operation, the device must be installed on a safe
and solid surface.
When mounted on the trolley, the trolley must be in
the upright position!
ATTENTION!
The device must be mounted correctly before use. It
must also be checked that the filter elements are
correctly mounted and efficient.
The device should only be operated, mounted,
repaired and transported on a stable, safe and not
reclined surface.
WARNING!
Before starting up the appliance check that it is
receiving water correctly; use of the appliance
without water will damage it. Do not cover the venti-
lation grilles when the appliance is in use.
To prevent damage to the appliance, do not allow it
to operate dry and check that it is properly supplied
with water.
WARNING!
Toxic carbon monoxide is contained in the motor
exhaust gas. Never run in a closed area.