cleanAIR 510000, User Manual

Page: 9 / 144

9
Additional restrictions for Chemical 2F Ex
• Before working in a potentially explosive atmosphere, it is essential that the user knows the boundaries of the zone.
• To use the Chemical 2F Ex in an explosive atmosphere, it is essential that the user is dressed in clothing that complies
with EN 1149-1 or EN 61340-4-9.
• The user may only enter the zone with the filter-ventilation system in place and switched on.
• The battery must not be charged in an explosive atmosphere.
• In the zone, the user may only wipe the lens with a damp cloth.
• It is forbidden to enter the zone with a battery that is not secured by a safety screw.
• The user must not remove the battery in the zone.
• Equipment classification must meet the requirements of the employer’s explosion protection document, ie the “Exlosion
Protection Document (EPD)”.
3. Unpacking / Assembly
3.1. Unpacking the CA Chemical 2F Plus
Check whether the package contents are complete and that nothing has been damaged during transport. The complete system,
including accessories, contains the following components:
510000 510000FCA 510000FDA 510000ASD 510000SER 51E000 51E000FD
Chemical 2F plus
Chemical 2F plus, “Asbestos” mode
✓
Chemical 2F plus, demo unit
✓
Chemical 2F EX
✓ ✓
Exchangeable battery
✓ ✓ ✓ ✓ ✓ ✓
Comfort padded belt
✓ ✓
Decontaminable PVC belt
✓ ✓ ✓
Light flexi hose QL
✓
Transport case
✓
Flow indicator
✓ ✓ ✓ ✓ ✓ ✓ ✓
Battery charger
✓ ✓ ✓ ✓ ✓
User manual
✓ ✓ ✓ ✓ ✓ ✓
3.2. Assembly
1. Insert the battery into the unit.
2. Connect the hose to the PAPR unit and make sure the connection is tight enough.
3. Attach filters to the unit - make sure they are both the same type!
4. Connect the hose to the headtop.
4. Before use
4.1. Control procedure before every use - make sure that:
1. All components are in good condition without any visible damage. Replace every damaged and worn out part.
2. The hose is connected correctly to the PAPR unit as well as to the headtop.
3. Airflow is sufficient (Section 4.2.).
4.2. Airflow test
1. Disconnect the air hose from the unit.
2. Connect the flow indicator to the unit.
3. Switch the PAPR unit on.