
14
OPERATIONS MANUAL
15
RHINO-MAT
Control Panel Dip Switch Configuration
The first step to setting up the bill and coin system is to figure out these three factors:
The
Length of Time
(in seconds)
you plan to give
your customers per cycle:
1 minute = 60 Seconds
The
Dollar Amount
(in quarters)
you plan to charge
your customers per cycle:
1 dollar = 4 quarters
Also, it is important to note that 1 quarter = 1 pulse; so 4 quarters = 4 pulses.
Locate Control Panel Dip Switches 1-8 in the Control Box located on the inside
of the Right Side Door.
Self-Serve Configuration
The following procedures DO NOT apply to the Full-Serve, Push Button
Start models.
Configuring Control Panel Dip Switches 1-5 for Time
1. Determine the length of time per cycle in seconds
(i.e. 2 minutes=120 seconds).
2.Next, determine the dollar amount to be charged per cycle in quarters
(i.e. $2= 8 quarters [each quarter= one pulse]).
Once you have these two numbers, plug them into the following equation:
_______________ ÷ ______________ = _______________
3. Finally, once you have the “DIP Switch Settings for Time”, find the number
under the Seconds column on the Control Box DIP SW Chart for Setting
Time (Located on Page 15). These are the settings that DIP switches 1-5
should be set to.
NOTE: You will need to round the number up or down if you end up with
a fraction (i.e. 24.5 can round up to 25 or down to 24).
Seconds
DIP SW 1
DIP SW 2
DIP SW 3
DIP SW 4
DIP SW 5
1
OFF
OFF
OFF
OFF
OFF
2
OFF
OFF
OFF
OFF
3
OFF
OFF
OFF
OFF
4
OFF
OFF
OFF
5
OFF
OFF
OFF
OFF
6
OFF
OFF
OFF
7
OFF
OFF
OFF
8
OFF
OFF
9
OFF
OFF
OFF
OFF
10
OFF
OFF
OFF
11
OFF
OFF
OFF
12
OFF
OFF
13
OFF
OFF
OFF
14
OFF
OFF
15
OFF
OFF
16
OFF
17
OFF
OFF
OFF
OFF
18
OFF
OFF
OFF
19
OFF
OFF
OFF
20
OFF
OFF
21
OFF
OFF
OFF
22
OFF
OFF
23
OFF
OFF
24
OFF
25
OFF
OFF
OFF
30
OFF
OFF
35
OFF
OFF
40
OFF
45
OFF
OFF
50
OFF
55
OFF
60
Control Box DIP SW Chart for Setting Time
LENGTH OF TIME
Per cycle
in seconds
DOLLAR AMOUNT
to be charged per
cycle in quarters
DIP SWITCH
Settings
for Time