6
Select replacement jaw set and assemble them in the reverse order of operations.
Note: If the cylinder shaft won’t retract when being cycled the adjustment of both
set screws on the front cylinder mount bracket will need to be adjusted. To make the
adjustment you must first loosen the two 6x12mm screws using a 5mm hex wrench
(
Figure 3.2.7.)
and then by adjusting the two set screws using a 3/32
nd
hex wrench.
(
Figure 3.2.8.)
Now tighten the two 6x12mm screws and ensure jaw alignment.
6x12 mm screws Set Screw
Figure 3.2.7
Figure 3.2.8
