8
Figure 3.2.3
Using
a 3/8” open end wrench to hold the flats on the cylinder shaft and an 11/16” open
end wrench on the hex nut, break the upper jaw nut loose by turning it counter clockwise.
Figure 3.2.4
Using a 9/16 open end wrench break the lower jaw nut loose by turning it clockwise.
Figure 3.2.5
Figure 3.2.4
Figure 3.2.5
Now remove the two 5x20mm screws holding the front cylinder mount bracket using a
4mm hex wrench.
Figure 3.2.6.