CLEAN REMOTE FOR MULTI-BED TV INSTRUCTIONS
FOR HEALTHCARE TVs WITH THIS FUNCTION ONLY
CR3BCB-H
Battery Installation:
1. To open cover: With keypad facing you, first slide dark lens cover away from you (photo A, step 1)
and then lift lid upward from the back (photo A, step 2)
2. When placing
two
AAA batteries
in the compartment note the + and - symbols on the metal hinge
should make contact with the corresp and - end of each battery (photo B).
3. Closing cover:
With keypad facing away from you
gently close cover by pressing downward
(photo C, step 1) and sliding it toward the front (keypad) until it is aligned. (photo C, step 2)
4. Test remote by pressing the power button; the LED should light, indicating that the batteries are in
co
rrectly. If the LED doesn’t light, then the batteries are either in wrong or the batteries are bad.
Photo A
Photo B
Photo C
Open with
keypad facing you
Close with
keypad facing away
from you
IMPORTANT
Before proceeding, please insure that your TV has the Multi (bed)-Code feature and the TV has been set
to the appropriate Multi (bed)-Code setting.
You will need to refer to your TV’s manual for TV Multi (bed)-
Code setup instructions.
1) Press and Hold the SETUP button on the remote for approximately two seconds then also Press and
Hold the ENTER button. Once a solid red light appears on the remote release both buttons.
2) Enter the corresponding 3 digit Multi-bed code from the list below.
Test the remote to insure proper operation; If everything is working you are done, if not please insure your TV
is also set to the correct Multi-Bed code and repeat Step 2 above.
Optional screw for
the battery
compartment is in
bag with remote
