instructions for use
4 TransPOrT, seTTinG UP
4.1 saFety regulatiOns
4.1.1 Temporary storage
Always keep the unit in its outer packaging and in a dry room indoors.
4.1.2 Unpacking
Without using sharp tools, remove the outer packaging carefully.
Keep the original packaging. Always use it for storing and transporting the
unit.
4.1.3 Putting the machine into operation
• check that the mains voltage is the same as that on the type label and is
the same as the setting
• using the mains cable connect the unit to the mains voltage
push the red cable into the red connecting socket (5)
• fix the earthing clamp to the red cable and then on the workpiece
• push the black cable into the black connecting socket (6)
• fix the other end of the cable into the tool for lettering/cleaning
• switch on the unit at the main switch (11), the yellow light (7) should
be lit, the unit is ready
• set the unit as desired
5 OPeraTinG
5.1 initial OperatiOn
Carry out a check and inspection, not only prior to initial operation, but also
prior to every set up. Set up the unit as described above.
Working with chemicals can be dangerous. Always wear a face mask,
acid-proof apron, goggles and gloves. When using Greinox 1000 / 2000 /
Polish, Rapid please read the Safety Data Sheets first (currently to be
found under www.greising.com / Clean Marker /Service).
Do not ingest the vapours arising. Should there be skin contact, wash with
plenty of water.
Operation Manual Clean Marker Brush
−
Page 12
