Clean Island Breathing 1500/3000 Portable Air Filtration System Manual 2014
Opening the cabinet
1. Turn the unit off and unplug it.
2. Unscrew the 5 lid screws. Once all five
screws are out, remove the metal cover.
3. Bracing the unit so
it does not move,
turn the HEPA
cartridge counter-
clockwise and lift/
pull out.
Pre-filter
1. Pull the pre-filter
up and off the unit.
NOTE: The pre-fiter may contain
contaminants, remove it slowly to avoid
releasing particles back into the air.
2. Foam pre-filters can be washed several
times, wash by hand in warm water. Let it
dry completely before placing it back onto
the HEPA cartridge.
3. If replacing the filter,
remove plastic shrink
wrap from the new pre-
filter.
4. Stretch the new/washed
filter around the top of
the HEPA cartridge and
slide it down into place
HEPA filter
1. Place the HEPA cartridge gently into the
unit.
2. When the HEPA cartridge is in place,
brace the unit, press down and gently
turn it clockwise to lock it into place. If too
much force is used, the cartridge may be
difficult to remove!
3. If replacing the HEPA filter with a new
filter, discard old HEPA filter and use new
when replacing the HEPA filter into the
unit.
4. With each annual filter replacement kit,
a new ‘o’ ring is provided. The old one
is removed by pinching it between two
fingers and pulling it off the collar on the
blower deck.
5. Discard old ‘o’ ring.
6. Place the new ‘o’ ring onto the collar and
slide it down to the base of the blower
deck.
Inner Carbon Filter Replacement
1. Look inside the HEPA cartridge to locate
the two ends of the inner carbon filter.
2. Pull one end of the old inner carbon filter
in and bend it into a loose roll so it can be
removed.
3. Remove the inner carbon filter from the
HEPA cartridge.
4. Remove plastic shrink wrap from the new
inner carbon filter.
5. Unroll the inner carbon filter and roll it
up in the opposite direction (this makes
the filter follow a more contoured profile
against the inner HEPA
filter surfaces and helps
keep it in place), place the
rolled inner carbon filter
inside the HEPA cartridge
and gently unroll it until the
ends ‘butt’ together and the
filter is snug against the
HEPA filter.
V.O.C. Canister (OPTIONAL)
1. Remove old Carbon Filter by pulling it out
from the inside of the HEPA filter.
2. Remove the plastic shrink wrap from the
new carbon canister.
3. Place the carbon canister inside the Air
Filtration System, smaller end first.
4. Slide the HEPA Filter over the V.O.C.
Canister and down into the Air Filteration
System.
5. Gently, turn the HEPA Filter until it locks
into place.
Closing the cabinet
1. Position the top cover on the unit with the
centered screw hole at the rear of the unit.
2. To replace the lid screws, apply firm
pressure to the top cover to align the
holes and then insert and fasten screws.
3. Plug the unit in and turn it on.
MAINTENANCE: FILTER REPLACEMENT INSTRUCTIONS
When a red LED filter light is flashing...
HEPA Filter Replacement
As the HEPAfilter captures particulates, it
will darken over time. Replace the HEPA
filter when it darkens to example D.
A. New
B. Used
C. Used
D. Replace
