Repair or Warranty Contact
Clayton Associates, Inc. • 1650 Oak Street • Lakewood, New Jersey 08701 • P.+1-732-363-2100 F.+1-732-364-6084
WH-4
Page 6
The vacuum has the following compressed air requirements to function properly:
• Compressed air must be clean, dry, and oil free to prevent blockage of the pneumatic system.
•
Compressed air line and fittings must have a minimum diameter of 1/2 in (13 mm).
Compressed Air Plug (Air In)
•
The Vacuum is supplied with a 1/2 in (13 mm) industrial interchange compressed air plug for connection to your compressed air supply.
The Compressed Air Plug may be changed to another nominal 1/2 in (13 mm) style if required.
•
Hold the Compressed Air Control Valve with a 7/8 in (22 mm) open end wrench.
•
Remove the compressed air plug with either a 7/8 in (22 mm) deep socket or 7/8 in (22 mm) open end wrench.
• Install a new compressed air plug.
Compressed Air Coupler (Air Out)
•
The Vacuum is supplied with two 1/4 in (6 mm) brass high flow compatible industrial interchange compressed air couplers.
• This coupler provides convenient pass through compressed air for an air tool connected to the vacuum.
The Compressed Air Coupler may be changed to another nominal 1/4 in (6 mm) style if required.
•
Hold the brass bulkhead fitting with a 1 in (26 mm) open end wrench.
•
Remove the compressed air coupler with a 3/4 in (19 mm) open end wrench.
• Install a new compressed air coupler.
1. Attach the vacuum hose.
• Open the Inlet Port on the vacuum tank.
• Insert the metal sleeve of the vacuum hose into the Inlet Port on the vacuum tank.
2. Activate the vacuum.
• Rotate the Compressed Air Control valve to the ON position.
COMPRESSED AIR FITTINGS
BEFORE EACH USE