Clayton Steam Generator model EO-100-1M
PAGE 6 / 70
Instruction Manual, doc.nr.: MAN18206 Rev A PSC
CHAPTER 2 :
SAFETY INFORMATION
2.1
GENERAL, IMPORTANT INFORMATION
Read this instructions carefully, and look at the equipment to become familiar with the steam generator
before trying to install, operate, or service it.
Never install or start-up damaged products. Make a complaint about the damage to shipping company
immediately.
Installation, start-up, operation and maintenance may only be performed by qualified and authorized
personnel with the relevant training in accident prevention, in compliance with the valid regulations.
Normal ratings
(pressures, temperatures, time settings, etc.)
shall be durably marked.
Any modification on the steam generator shall only be performed in agreement with Clayton Industries, and
under supervision of authorized, competent personnel.
The owner is responsible for maintaining the unit in a safe operating condition. Parts and accessories shall be
replaced if unsuitable for safe operation.
Never remove or tamper with the safety devices, guards or insulations fitted on the unit. Every pressure
vessel or auxiliary installed outside the unit to contain gases or liquid above atmospheric pressure shall be
protected by a pressure-relieving device or devices as required.
The following special messages may appear throughout this documentation or on the equipment to warn of
potential hazards or to call attention to information that clarifies or simplifies a procedure.
DANGER
Indicates an imminently hazardous situation, which, if not avoided, could result
in death, serious injury, or equipment or environment dammage.
WARNING
Indicates a potentially hazardous situation, which, if not avoided, could result in
death, serious injury, or equipment or environment dammage.
CAUTION
Indicates a potentially hazardous situation, which, if not avoided, could result in
serious injury or equipment or environment dammage.
2.2
INSTALLATION
Apart from general engineering practice in conformity with the local safety regulations, the following
directives are specially stressed:
A steam generator or its auxiliary equipment shall be lifted only with adequate equipment in conformity with
local safety rules. Loose or pivoting parts shall be securely fastened before lifting. It is strictly forbidden to
dwell or stay in the risk zone under a lifted load. Lifting acceleration and retardation shall be kept within
safe limits.
Wear a safety helmet when working in the area of overhead or lifting equipment.
Any blanking flanges, plugs, caps and desiccant bags shall be removed before connecting up the pipes.
Distribution pipes and connections shall be of correct size and suitable for the working pressure.
Pipework or other parts with a temperature in excess of 80 degrees celsius and which may be accidentally
touched by personnel in normal operation shall be guarded or insulated.
Other high-temperature pipework shall be clearly marked.
