GETTING STARTED
2
Short Spring
Repair or Warranty Contact
Clayton Associates, Inc.
•
1650 Oak Street
•
Lakewood, New Jersey 08701
•
P.+1-732-363-2100 F.+1-732-364-6084
www.DustlessMadeSimple.com
•
What’s Included:
The Drill Shroud is shipped in 5 pieces. The Shroud Assembly, 2 Tip Assemblies, a Short Spring, and Hose Assembly shown below.
Note:
Some models may include a drill already mounted to the Shroud Assembly.
Mounting The Drill:
Always disconnect the tool from power before connecting or disconnecting the Dust Collection Shroud from any tool.
The Drill Shroud will mount to non-reversible drills that have a 3/8-24 threaded chuck.
• Remove the black plastic disposable spacer from between the Shroud Clamps and discard
• Follow the manufacturer’s instructions to remove the chuck from your drill
• Thread the drill chuck onto the male threaded side of the chuck adapter
• Thread the drill spindle into the female threaded side of the chuck adapter
• Tighten the assembly
Hose Length:
The vacuum hose included with the
tool may be shortened to suit your
particular needs. The hose can be
easily cut to the desired length with
a knife or hose cutting tools. Follow
all safety instructions provided with
cutting tools to prevent injury.
Chuck Adapter
Male Thread
Chuck Adapter
Female Thread
Tip Assembly #2
1.7 diameter
Plastic Spacer
Short Spring
Shroud Assembly
Hose Assembly
Switching Springs:
The Drill Shroud comes assembled with a standard spring. When using very short drill bits you may
need to use the short spring, included.
• Remove the Tip Assembly by retracting the Pull Pin and sliding the Tip Assembly off the Drill Tube
• Loosen the thumb screw on the Front Stop and slide it off the Drill Tube
• Remove the current spring and replace with the desired spring
• Reassemble
Switching Tip Assemblies:
The Drill Shroud comes with 2 Tip Assemblies to accommodate different diameter drill bits
and microstop countersinks.
• Remove the Tip Assembly by retracting the Pull Pin and sliding the Tip Assembly off the Drill Tube
• Align the Tip Assembly with the Drill Tube so that the Pull Pin will engage the hole in the Drill Tube
• Retract the Pull Pin on the desired Tip Assembly and slide onto the Drill Tube
Tip Assembly #1
1.1875 diameter
Pull Pin
Front Stop
Standard Spring
Tip Assembly